7 Reasons Your AC Causes High Electric Bills
I hope many of you are accustomed to high energy bills due to your air conditioner! But, have you observed that every year it becomes higher than the previous year? You must be bothered why your AC is becoming so expensive for you to bear.
Air conditioners require a lot of electricity. A loss in efficiency will lead to high electric bills. There could be various reasons for the loss in efficiency and they are as follows-
Duct Leaks
The ductwork circulates air throughout the indoor. Its role is very significant for the effectiveness of the system as it generates the expected results from your air conditioner. If there is any duck leak, then it minimizes the potentiality of the system for air circulation. It also affects the thermostat as the AC consumes a longer time to satisfy the thermostat and eventually slogs more, even harder. So, it is obvious that if the unit runs longer and harder to accomplish substandard results, it is bound to cause high electric bills.
Accurate airflow is necessary for a healthy system, which will be efficient enough. Else you need to seek professional AC repair in California.
Dirty Air Filter
Air filters maintain the cleanliness of the ducting, indoor coil, and air-handler of your home. If
they aren’t routinely altered; debris will accumulate after a lot of air is filtered. They can become so dirty that they obstruct airflow throughout the ductwork. Limited airflow will compel your unit to consume a long time to cool down your home. More run times can propel high electric bills due to overheating compressors and motors. Certain reusable filters are there that you may simply clean off and there are replaceable ones too that must be changed after every month. The replaceable ones ensure better airflow. This is the simplest thing you can do for maintaining your unit and avoid high energy bills.
Low Refrigerant
Air conditioners and heat pumps, both employ refrigerants for transferring heat and removing it from the home. It could be either r-22 Freon or r-410a Puron. Low refrigerant doesn’t let your system remove heat completely. If the units run low, then you will observe a hike in your bills as the system needs to slog harder for satisfying the thermostat. The cause of low refrigerant is mostly a leak, as they may take place throughout the system of coils and line sets that transmits the refrigerant. Call up a professional technician to correctly probe if there is a leak, its source, and what should be done as a solution.
Defective Parts
The defective parts on the system such as capacitors, motors, and the compressor will lead to a high energy bill. The decline in production due to a malfunctioning part will make the system less efficient. In the case of a defective condenser motor on the condenser and your attempt to chill indoors, the motor won’t remove heat from your home properly. The motor trying very hard and the thermostat not being satisfied will eventually compel the motor to run longer and lead to high energy bills. This may persist till your motor fails and you suffer due to the breakdown of your AC.
Poor Installation
It may so happen that the unit was not at all installed properly. The contractor could have oversized the unit, leading it to a short cycle, and kick on and off speedily. That will lead to high electric bills as air conditioners utilize the maximum energy at the beginning and are more productive if startups are minimized. Several other issues from poor installations could be poor electrical connections, missing parts, poor brazing and welding, and non-sealed duct connections. A poor installation can cause several annoying failures.
Obsolete System
A back-dated AC possibly suggests that your system isn’t efficient enough. You need to keep a track of the ratings Few units are so old and less maintained that they are compelled to rust out. Then you may require air conditioning replacement in California.
Poor Maintenance
If an HVAC expert visits you and checks the air conditioning system, it will help you in the long run with proper system efficiency and thwarting probable failures. This is also one of the ideal things you can do for preventing high energy bills as the technician is equipped with all the tools required to ascertain the condition and performance of your system and its components. Listen to the suggestions of the technician like replacing a capacitor, cleaning a coil, or availing of a programmable thermostat.
Inference
Plan regular maintenance or an estimate for a new unit with an HVAC professional, if you are still receiving high electric bills.
Comments
Post a Comment